Contents: Removal ↡ Installation ↡
Removal
1. Remove the front bumper.
2. Remove the turn signal lights.
3. Remove the inner wing.
4. Remove the decorative strips (moldings) by hand or press them off with a wide plastic spatula.
5. Open the door and remove the rear wing bolts from the car.
Attention! When doing this, tape the door in the working area to avoid damaging the varnish coating.
6. Unscrew the wing from below.
7. Unscrew the wing from above (five bolts) and below in the bumper area.
8. Remove the two bolts in the turn signal recess.
9. Remove the bolts on the hood below the headlight and remove the hood.
10. Pull the wing forward and remove it.
Installation
1. Apply a generous amount of underbody protective lubricant to the inside of the vehicle fender.
2. Install and align the fender. The fender should be level with the closed front door or be higher by a maximum of 1 cm. The gap between the fender and the closed engine hood and the front door should be checked.
3. Screw in all mounting bolts and tighten smoothly.
4. Check the position of the car wing again.
5. Seal the cavity above the inner fender with wax through the turn signal cutout.
Attention! Cover the hole on top of the wing with adhesive tape before applying wax. Remove the tape after applying wax.
6. Install the bumper.
7. Install the inner wing.
8. Install the flashing turn signal.
9. Secure the decorative strips.
(Read more on the website: www.MercedesMan.ru)