Removal and installation of CV joints of drive shafts and their protective covers (Mercedes-Benz S-Class W140)

Removal

Design of drive shaft joints and installation details of their protective covers
37a - Drive shaft; 37b - Outer hinge; 37c - Inner hinge; 37d - Joint hub; 37th - Ball; 37f - Separator; 37g - Retaining ring; 37h - Lid; 37i - Oil seal; 37k - Clamp; 37l, 37m - Protective covers

1. Remove the drive shaft.

2. Remove the clamps (37k).

3. Remove the cover (37h) and seal (37i) on the hinge ring (37c).

4. Remove the retaining ring (37g).

5. Remove the protective cover (37l) with the seal (37i).

6. Remove the inner joint (37c)-(37f) from the drive shaft.

7. Remove the protective cover (37m).

Installation

Installation is carried out in the reverse order of removal. About 120-150 g of grease will be required to fill the inner hinge, and 120 g for the outer hinge.

[Article obtained from this portal: www.MercedesMan.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article has been verified: Polyakov Zakhar Grigorievich

Share with friends:

◀ Previous

S-Class W140 / Clutch and drive shafts

Next ▶

Removal, checking and installation the drive shaft
Removal and installation the drive shaft flange and radial thrust ball bearing
Drive shafts — general information
Removal and installation the propeller shaft
Removal and installation the clutch slave cylinder

More similar articles for repairing other models