Removing
Raise the car from behind.
Disconnect ground from battery.
Open and close the gas tank cap to equalize the pressure.
Unscrew the protective cover.
Clamp the fuel supply hose with a screw clamp.
Unscrew the fuel line hoses from the accumulator, pump and filter.
Remove the fuel hose from the fuel pump, after releasing the clamp.
Disconnect wiring.
Loosen the 2 fixing screws and remove the pump.
Installation
Insert fuel pump with plastic sleeve.
Screw the fuel lines to the accumulator, pump and filter using new gaskets.
Tighten the mounting screws of the holder.
Attention: The plastic sleeve must protrude from both sides of the holder. Under no circumstances should the holder be placed directly on the fuel pump.
Put the fuel hose on the pump and secure with a clamp.
Connect electrical wiring. In the assembly position, the connector terminals must be vertical.
Remove the clamp from the fuel supply hose.
Connect ground to battery.
Start the engine and check the tightness of the fuel line connections.
Screw on the protective cover.
Take the car off the stands.