Note: If in cars with a cruise control there are jolts when using the cruise control at a speed above 60 km/h, then it is necessary to remove the cruise control relay and short-circuit terminals 2 and 3 with an auxiliary wire. If the malfunction does not appear again during a test drive, replace the cruise control relay. Otherwise, look for a break in the circuit according to the diagram.
Check whether the control link lever is in contact with the idle speed limiter of the cruise control. To do this, unhook the rod (21) and press the lever opposite the idle speed limiter clockwise.
After this, hook the barbell again; in this case, the control link lever should deviate approximately 1 mm from the idle speed limiter.
Otherwise, replace the rod. Press the ball bearing, loosen the lock nut, unscrew or screw the ball bearing and tighten the lock nut again.