3 - Gear selector lever; 33a - O-ring; 34 - Conical thrust; 35 - Doggy; 36, 60 - Bolts; 50 - Thrust; 51 - Guide sleeve; 51a, 55a, 141a - O-rings; 51b - Guide spring; 52, 56 - Retaining rings; 53 - Locking pawl «parking lot»; 54 - Spring; 55, 141 - Fingers; 139 - Locking pawl; 140 - Torsion spring
Removing
1. Remove the shift lever by unscrewing the bolts (60).
2. Take off the dog (35) together with conical rod (34).
3. Remove the bolt (36).
4. Remove your finger (141).
5. Remove the pull (50) from the transmission housing and unhook the locking pawl (139).
6. Remove retaining ring (52) with guide bush (51).
7. Click the pawl (53) blocking at «parking lot» opposite the spring (54) and press out the guide bush (51) from the transmission housing.
8. Remove retaining ring (56) and finger (55).
9. Take off the doggy (53) blocking at «parking lot» with spring (54).
Installation
1. Set the pawl (53) blocking at «parking lot» and spring (54) into the transmission housing and install the pin (55) with retaining ring (56).
2. Press in the lock pawl when «parking lot» (53) opposite the spring (54) as far as it will go and insert the guide bush (51) into the transmission housing so that the pawl teeth (53) blocking at «parking lot» installed in the middle of the guide bushing.
3. Install retaining ring (52).
4. Install traction (50) into the transmission housing and attach the locking pawl.
5. Set your finger (141).
6. Tighten the bolt (36).
7. Install pawl (35) conical traction (34).
8. Attach the gear selector lever (33).