Attention! When removing and installing, do not damage the surface of the protective material of the cover.
Removing
1. Raise the vehicle.
2. Remove front cover (1), unscrew the four bolts (arrows).
3. Remove back cover (2), by unscrewing the eight fixing screws. If necessary, remove the side trim on the left and right by unscrewing the two bolts securing the side trim to the side member and one bolt to the lower support of the transverse arm of the independent suspension, respectively.
Installation
1. After dismantling, install the side trim and secure with bolts.
2. Install rear trim and secure with bolts.
3. Install the front skin so that the groove in front enters the partition of the side of the skin (3).
4. Click on the front cover (1) up, while the edge of the side of the skin (3) should be on top of the cover (1).
5. Tighten the front trim bolts.
6. Lower the car to the ground.