Removing
1. Switch off the ignition by turning the key to the position "ABOUT".
2. Remove the battery ground wire (–).
Attention! This erases the engine fault memory or radio anti-theft code. Read the instructions before disconnecting the battery subsection 13.1.7.
3. Unscrew the 2 bolts of the airbag unit on the left and right on the back of the steering wheel while holding the unit.
4. Remove the block from the steering wheel and remove the wire plug on its reverse side.
Installation
Attention! If the airbag has been inflated, the steering wheel should be replaced. Follow the instructions for handling the pillow.
1. Connect the electrical connector to the airbag unit, you should hear a click.
2. Insert the block, tighten the two fixing bolts with a torque of 6 Nm.
3. Connect the battery ground wire (–).
4. If available, set the time on the clock, as well as the anti-theft code of the radio.