Contents: Removal ↡ Installation ↡
Removal
Oil filter housing installation details
8 - Guide bushings; 9 - Oil filter gasket; 10 - Oil filter housing; 15 - Sealing rings 24 - Connector; 25 - Cooling system hose; 26 - Protective wire cover; 29 - Oil pipelines
1. Disconnect the negative cable from the battery.
2. Remove the compressed air supply distribution tube.
(Full article available on the resource: «MercedesMan.ru»)
3. Drain the engine oil from the oil filter.
4. Unscrew the oil lines (19) from the connector (24).
5. Remove the bracket (28) securing the exhaust gas recirculation pipe.
6. Unscrew the protective cover of the wires (26) and the branch pipe (25) of the cooling system from the oil filter housing.
7. Disconnect the wiring connector from the crankshaft position sensor.
8. Remove the starter.
9. Remove the oil filter housing (10).
Installation
Installation is carried out in the reverse order of removal.