Electronic Steering Column Lock (ELV) Mechanism Installation Details
37m - Mounting bolt
37p - Connector
71 — Column sleeve
N₂6/5 — Electronic lock control module
1. On models with the corresponding configuration (code ET2), activate the service mode of the TELE AID emergency call system (see Section Activation/deactivation of the service mode of the TELE AID emergency call system).
2. Remove the lower section of the instrument panel trim from the driver's side of the vehicle (see Chapter Body).
3. If equipped, remove the knee support (see Chapter Body).
4. Turn towards the sample and remove the mounting bolt (37m).
5. Release the electronic locking system control module (N₂6/5) from the steering column sleeve (71)
6. Turn on the auxiliary battery and connect it to the standard battery, then disconnect the negative cable from the latter.
7 - Auxiliary battery
8 — Positive wire terminal of the module
9 — Terminal of the negative wire of the module
W10 - Battery ground
7. Disconnect the connector (37p).
8. Installation is carried out in reverse order.
9. If equipped accordingly, deactivate the service mode of the TELE AID system.
10. Finally, clear the memory of the on-board diagnostic system processor (see Chapter Engine electrical systems).