24. Brake pedal
S9. Stoplight switch
Removing
1. Switch off the ignition.
2. Remove the left cover under the dashboard.
3. Disconnect the wire plug from the brake light switch.
4. Press the latch (S9b), turn the switch and remove.
Installation
1. Pull out the switch pin (S9a) on the new switch. This results in the maximum pin path (A).
2. Fully depress the brake pedal. Install the switch and turn it until the lock (S9b) got caught up.
3. Release the brake pedal, and the switch pin path will self-adjust.
4. Plug the wire plug into the brake light switch.
5. Install the cover under the dashboard.
6. Check if the brake lights come on when you lightly press the brake pedal.
Attention! Check the brake light switch.