Contents: Removal ↡ Installation ↡
Cardan shaft
2 - Cardan shaft; 5, 21, 200a - Bolts; 6, 20, 36 - Washers; 7, 35, 88, 200 - Nuts; 18 - Engine support; 19 - Engine bracket; 56 - Seal; 87 - Flange
Removal
1. The cardan shaft with connections is shown in the accompanying illustration.
2. Raise the gearbox with a jack.
3. Unscrew the engine support mounting nut 35. Unscrew the bolts 21 with washers and remove the engine bracket 19 together with the support 18.
4. Unscrew the cardan shaft from the gearbox. Unscrew bolt 8 securing the speedometer shaft 9 and remove it.
5. Loosen the mounting bushings in the cardan flange. To do this, use a punch with a diameter of 10 mm and a length of approximately 150 mm.
6. Loosen the driveshaft nut and move the driveshaft away from the flange towards the rear of the vehicle.
7. Unscrew bolts 200a.
Installation
Installation is carried out in reverse order.