Hood installation details
1 - Locker; 2 - Nut; 3 - Hood hinge; 4 - Castle; 5 - Buffer; 6 - Radiator panel; 7 - Bottom buffer; 8 - Hood
Hood lubrication points
Longitudinal adjustment
1. Remove the mudguard. 2. Set the hood to a vertical position (90°) and unhook the spring (1) from the hood hinge.
3. Loosen the nuts (4) securing the hood hinges.
4. Adjust the position of the hood so that the front edge of the front fender is aligned with the front edge of the hood. Tighten the hood hinge nuts.
5. Install the front wheel arch protection liner.
Lateral adjustment
1. Loosen the bolts (arrows) securing the hood lock (5).
2. Adjust the hood installation (5 mm).
3. Tighten the hood lock mounting bolts.
Height adjustment
1. Remove the mudguard. 2. Loosen the nuts on the left and right buffers.
3. Adjust the bumper so that the top edge of the closed hood is aligned with the top edge of the turn signal.
4. Position the hood vertically (90°) and unhook the spring (1) from the hood hinge. Close the hood.
5. Loosen both rear nuts (4) securing the bonnet hinges. Do not loosen the front nuts, otherwise the longitudinal adjustment of the bonnet will change.
6. Adjust the hood so that the top edge of the rear of the hood is aligned with the top of the front fender, then tighten the hood hinge nuts. Set the hood vertically (90°) and hook the spring to the hood hinge. Close the hood.
