Models released on 11/30/00
Instrument cluster installation details (models produced up to 11/30/00)
1, 2 - Electrical wiring connector; A - Connector disconnected; B - Connector is connected; A1 - Instrument cluster
1. Disconnect the negative cable from the battery.
2. Pass the removal hook into the gap between the instrument panel and the combination (A1) - try not to damage the plastic.
3. Release and disconnect the electrical wiring connectors (1 and 2).
4. Release the combination (A1) from the panel.
5. Installation is carried out in reverse order.
Models released from 01.12.00
Instrument cluster installation details (models produced from 01.12.00)
1 - Facing overlay; 2 - Electrical wiring connector; A1 - Instrument cluster
Read more on the website Mercedesman.ru
1. On models with the corresponding configuration (code ET2), activate the service mode of the TELE AID emergency call system (see Section Activation/deactivation of the service mode of the TELE AID emergency call system).
2. Move the adjustable steering column to the lowest position and pull the steering wheel towards you as far as it will go.
3. Turn on the auxiliary battery and connect it to the standard battery, then disconnect the negative cable from the latter.
7 - Auxiliary battery
8 — Positive wire terminal of the module
9 — Terminal of the negative wire of the module
W10 - Battery ground
4. Using a suitable wedge, release the four fasteners and remove the trim panel (1).
5. Pass the removal hooks through the instrument cluster (A1), turn them with the curved ends outward, push them inward as far as they will go and fix them in the guides by pressing them slightly outward.
6. Rotate the hooks downwards by 90° and pull to release the combination (A1) from the instrument panel.
7. Disconnect the connector (2) and completely remove the instrument cluster (1).
8. Installation is carried out in the reverse order - if the corresponding configuration (code ET2) is installed, deactivate the service mode of the TELE AID system (see Section Activation/deactivation of the service mode of the TELE AID emergency call system).
9. Finally, read the DTC codes and clear the on-board diagnostic system memory using the STAR DIAGNOSIS scanner (6511 1801 00) (See Chapter Engine electrical systems).