Contents: Central speaker of the instrument…↡ High frequency speakers ↡ Door Speakers ↡ LF loudspeaker (harman/Kardon audio…↡
Central speaker of the instrument panel
Details of installation of the central speaker on the dashboard
1, 2 — Electrical wiring connectors; 3, 5 - Bolts; 4 - Panel; H4/27 - Central speaker
1. Turn on the auxiliary battery and connect it to the standard battery, then disconnect the negative cable from the latter.
7 - Auxiliary battery
8 — Positive wire terminal of the module
9 — Terminal of the negative wire of the module
W10 - Battery ground
2. Remove the central air vents from the instrument panel (see Chapter Body).
3. Remove the mounting screws (5) and remove the panel (4).
4. Disconnect the connectors (1 and 2).
5. Unscrew the mounting bolts (3) and remove the center speaker (H4/27).
6. Installation is carried out in reverse order.
7. Finally, read the DTC codes and clear the on-board diagnostic system memory using the STAR DIAGNOSIS scanner (6511 1801 00) (See Chapter Engine electrical systems).
High frequency speakers
HF Speaker Installation Details
1 - Bolts; H4/1h1 - Left HF speaker; H4/2h1 - Right HF speaker
1. Remove the side deflectors from the instrument panel (see Chapter Body).
2. Loosen the mounting screws (1) and remove the tweeters from the instrument panel (H4/1h1 and H4/2h1).
3. Disconnect the electrical wiring from the speakers.
4. Installation is carried out in reverse order.
Door Speakers
Front doors
Front Door Speaker Installation Details
1 - Connector; 2 - Bolts; H4/1 - Left door speaker; H4/2 - Right door loudspeaker
1. Remove the door interior trim panel (see Chapter Body).
2. Disconnect the electrical wiring from the speaker - connector (1).
3. Remove the mounting screws (2) and remove the door speaker (H4/1 or H4/2).
4. Installation is carried out in the reverse order - make sure that the speaker is correctly placed on the door.
Rear doors
Rear Door Speaker Installation Details
1 - Connector; 2 - Bolts; H4/5 - Left door speaker; H4/6 - Right door loudspeaker
The procedure is the same as described above for the front door speakers.
LF loudspeaker (harman/Kardon audio system woofer) (equipment code E66)
Installation details of the woofer of the Harman/Kardon audio system
1 - Protective grille; 2, 3 - Bolts; 4 - Electrical wiring connector; A - Cup holder; H4/29 - Low frequency loudspeaker (woofer)
1. On models with the corresponding configuration (code FG2), remove the rear cup holder.
2. Loosen the fastening screws (2) and remove the protective grille (1).
3. Remove the screws (3) and remove the LF speaker (H4/29).
4. Disconnect the electrical wiring connectors (4).
5. Installation is carried out in reverse order.