Contents: Models Universal ↡ Convertible Models ↡
Models Universal
Antenna splitter installation details on Universal models
1 - Lid; 2 - Plug connectors; 3 - Bracket; A28/1 - Antenna splitter (radio and cell phone)
1. Remove the cover (1) on the right under the instrument panel (see Chapter Body).
2. Disconnect the plug connectors (2) on the antenna splitter (A28/1).
3. Tilt downwards to release the divider (A28/1) from the support bracket (3).
4. Installation is carried out in reverse order.
Convertible Models
Antenna splitter installation details on Convertible models
1 - Antenna cable; 2 - Radio receiver cable; 3 - Cell phone cable; A28/1 - Antenna splitter; A28/1x1 - Power supply harness connector
1. Remove the right front wheel arch protection liner.
2. Pull and separate the antenna splitter (A28/1) from its mounting location on the wheel arch - prepare a replacement piece of double-sided tape.
3. Disconnect the power supply harness from the divider - connector (A28/1x1).
4. Disconnect the antenna cable (1) from the splitter, then the radio receiver (2) and cell phone (3) cables.
5. Installation is carried out in reverse order.