Contents: Removal ↡ Installation ↡
Removal
1. Contact chapter 1B and remove the filter element.
Turbocharged engines
2. On models with an incoming air temperature sensor attached to the air cleaner, disconnect the sensor wires from the connector.
3. Remove the bolts and/or nuts and lift the air cleaner housing off the body panel. If necessary, unhook the housing from the intake manifold pipe.
4. If equipped, loosen the hose clamps and disconnect the air duct that connects the housing to the air flow meter. Then remove the air cleaner housing from the engine compartment (see fig. 2.4).
Fig. 2.4. Air cleaner - turbocharged engines
A Air purifier
In the Input Knee
With Air Intake
D Cap-shaped seal
Engines without turbocharging
5. If necessary, disconnect the vacuum line from the control valve actuator.
6. Loosen the bolts and remove the front and rear support brackets and release the air cleaner from them, remove the rubber supports (see fig. 2.6).
Fig. 2.6. Air cleaner - non-turbocharged engines
And the Clamps
In Filter element
With Air Duct
D Air intake
E Brackets
F Rubber cuffs
7. Remove the air cleaner from the intake manifold and remove the rubber cuffs.
Installation
8. Installation is performed in the reverse order of removal. When finished, install the filter element in accordance with chapter 1B.