Contents: Removal ↡ Installation ↡
Removal
1. Remove the floor covering from the trunk.
2. Remove the interior trim around the rear light.
3. Remove the plug connector at the bottom of the lamp holder.
Installation
40. Plug connector; 41. Lamp holder; 42. Nuts 43. Reflector; 44. Lantern glass; 45. Compaction
1. Check the seal for porosity and damage, replace it if necessary.
2. Insert the rear light glass together with the seal from the outside into the body.
Read more on the website www.mercedesman.ru
3. Press the reflector in and tighten the mounting nuts evenly and tightly.
4. Insert the lamp holder and secure it by turning the plastic handle to the right.
5. Place the plug onto the connector.
6. Install the interior trim.
7. Turn the plastic handle on the tail light horizontally and remove the bulb holder.
8. Unscrew the fastening nuts (42).
9. Remove the rear light glass (44) together with the seal (43) and remove the reflector inward.