Contents: Removal ↡ Installation ↡
Note: If the key gets stuck in the lock cylinder, spray the latter with a special spray - if lubrication does not help, the cylinder should be replaced.
The details of the ignition lock cylinder installation are shown in the illustrations to which all references in the text refer.
Ignition Lock Cylinder Installation Details |
Ignition Lock Cylinder Installation Details |
Ignition Lock Cylinder Installation Details |
Ignition Lock Cylinder Installation Details |
Ignition Lock Cylinder Installation Details |
Ignition Lock Cylinder Installation Details |
Removal
1. Using a suitable hook, remove the transponder coil (L11) from the lock cylinder.
2. Turn the key in the lock to position 1, then a little further (until it clicks).
3. Turn the cover (36b) 90° counterclockwise to remove the lock cylinder (36).
Installation
1. Lubricate the cylinder (36) with special grease and seat it in the cover (36b).
2. Insert the key through the cover (36b) and insert it into the lock cylinder until it stops - the cams should be completely retracted.
3. Insert the cylinder (36) into the lock assembly, making sure that the tongues (arrow) of the cylinder (36) are aligned with the recesses in the lock (arrow).
4. Using the mandrel (011), turn the cover (36b) 90° clockwise until the lock clicks into place.
5. Turn the key in the cylinder to position 0 and remove the mandrel (011).
6. Place the transponder coil (L11) on the cylinder (36).