Checking and adjusting the level / changing the oil in the bridge assemblies (Mercedes-Benz G-Class W463)

Note: Checking and replacement must be performed with the axle gearbox warmed up.

Front axle

Examination

1. Thoroughly wipe the surface of the bridge housing around the filler/inspection plug (1).

2. Unscrew the plug - the oil level in the crankcase should reach the lower edge of the hole, if necessary, make the appropriate adjustments (use the funnel). Make sure the plug is tightened to the required torque.

Replacement

1. Prepare a drain container of suitable volume.

2. After wiping the surface of the crankcase around both holes, unscrew the filler (1) and drain (2) plugs.

3. Wait until the oil has finished draining, then screw the drain plug (2) back into place and tighten it to the required torque - if necessary, replace the sealing washer first.

4. Using a funnel, pour the required amount of fresh oil of the required grade into the gearbox housing - the oil level should reach the lower edge of the filler/inspection hole.

5. Screw in and tighten the plug (1) to the required torque.

Rear axle

The procedure is the same as described above for the front axle.

Article based on data from the website mercedesman.ru

Note: To ensure proper access to the filler/inspection plug, the vehicle must be lowered onto its wheels.