Front doors
Details of installation of the inside handle of the front door
1 - Plug; 2 - Bolt; 9 - Drive cable (Bowden)
1. Remove the cap (1), remove the bolt (2), release the latches, disconnect the drive cable (9) and remove the handle.
2. Installation is carried out in the reverse order.
Rear doors
Details of installation of the internal handle of a back door
1 - Plug; 2 - Bolt; 9 - Drive cable
The procedure is the same as described above for the front door.
Tailgate
Details of installation of the internal handle of a door of a back
1 - Built-in drive mechanism; 2 - Blocking spring; 3, 4 - Stoppers
1. Remove the inner door trim (see Section Removal and installation of an internal upholstery of door assemblies).
2. Gently squeeze and slide the drive mechanism built into the door assembly to the hinged edge of the door (1).
3. Release mechanism (1) just enough to expose the locking spring (2).
4. Depress the spring (2) from locking tongue (3), leaving her hooked on the tongue (4).
5. Disconnect drive rod.
6. Installation is carried out in the reverse order.