Removing
10. Disconnect the wire terminal from the negative pole of the battery «masses» (-), by turning off the ignition first.
Attention! When the battery is disconnected from the radio, the security code is deleted, as well as all automatic settings on the radio. If the code is unknown or not written down, the only way to put the radio into operation is with the assistance of a workshop or the manufacturer of the radio. Therefore, first make sure that the code is known.
11. Remove the overlay of the upper part of the center console, see relevant chapter.
12. Disconnect the three plugs 1 of the switch box (see illustration).
13. Press down with a screwdriver three stops (see arrows in illustration 32.12) and remove the switch box.
Installation
14. Connect the three plugs 1 of the switch box and fix them on the center console trim (see illustration 32.12).
15. Replace the front cover of the center console, see relevant chapter.
16. Connect ground wire terminal (-) to the battery post, making sure the ignition is off.
17. Set up the digital clock.
18. Enter the security code into the radio.