Windshield wiper motor installation details
1. Installation details of the electric motor drive windshield wipers are shown in the illustration, which includes all references in the text.
2. Remove the wiper drive assembly (see chapter Body).
3. Loosen the axle nut (1) and remove the screws (3) fasteners for the assembly of the electric motor (М6/1) drive rods (2).
4. Disconnect the wiring connector (Х88/2) and remove the drive motor assembly (М6/1).
5. Installation is carried out in the reverse order - make sure that the parking position of the drive is set correctly when screwing the axle nut (1) on the motor shaft, make sure that the drive lever is lowered vertically down.
Windshield wipers
Details of installation of the electric motor of a drive of a cleaner of back glass
1. The installation details of the rear window wiper motor drive are shown in the illustration, to which all references in the text refer.
2. Bring the drive into park position.
3. Remove the inner upholstery of the tailgate (see chapter Body).
4. Remove the rear window wiper arm (see chapter Body).
5. Remove high level brake light (see Section Removal and installation of the central brake light of the upper level).
6. Disconnect the electrical wiring connector (3).
7. Disconnect from the male connector (1) washer fluid supply pipe.
8. Remove the screws (2) fastening the drive assembly to the tailgate.
9. Remove the drive motor (М6/4).
10. Installation is carried out in the reverse order - if necessary, replace the door frame bushing.