Contents: Removal ↡ Installation ↡
Removal
1. Remove the bumper, see the relevant chapter.
2. Unscrew the four flat nuts on the back of the bumper that secure the corresponding trim and remove it.
3. Remove the adhesive layer from the overlay.
Installation
4. Drill holes for the protective pads in the new bumper without holes.
5. Remove the protective foil from the adhesive layer on the protective pad.
6. Fix the protective cover into the holes and press it onto the bumper.
7. Screw on and hand tighten the flat nuts securing the protective cover.
8. Install the bumper back into place, see the relevant chapter.