111 Series Engine CMP Sensor Installation Details
11/1 — Sealing ring
11/2 — Adjusting shim
L5/1 — CMP sensor
Adjusting the CMP sensor using a blade type feeler gauge
1. The installation details of the ignition coils of the 612 series diesel engine are shown in the illustration, - do not forget to replace the sealing ring (11/1).
2. After replacing the CMP sensor (L5/1), it is necessary to set the camshaft clearance: turn the crankshaft so that the camshaft sprocket segment is opposite the sensor and, using a blade-type feeler gauge, measure the clearance between the sprocket segment and the sensor - the required value is 0.5 mm, if necessary, make the appropriate adjustment by selecting an adjusting shim (11/2): 0.1÷1.0 mm.