2. Remove the center console by first removing its rear, then the center and finally the front.
3. Remove the gearshift mechanism.
4. Disconnect the spacer that connects the front beam to the bottom.
5. Lower the power block on the front beam.
Attention! Prepare four bolts for fastening the engine lowered down on the front beam to the bottom.
6. Fix the engine lowered down on a forward beam to the bottom.
7. Remove the engine protection from the front beam.
8. Set the shift fork rod 4 to position P (see illustration 5.0).
9. Disconnect the cable 1 gear selection from the rod shift fork 4 (see illustration).
6.9 Disconnect the selector cable 1 from the shift fork shaft
1 - gear selection cable
2 - case
3 - bracket
4 - shift fork rod
5 - clamp
10. Disconnect the bracket 3 of the gear selection cable from the transmission (see illustration 6.9).
11. Retract cable 1 gear selection into the passenger compartment (see illustration 6.9).
Installation of dismantled parts is carried out in the reverse order of removal.