Vehicles with a diesel engine.
Removing
1. Remove the intake manifold module, see relevant chapter.
2. Remove the heat shield.
3. Remove the radiator fan diffuser, see relevant chapter.
4. Separate the front pipe and the catalyst by unscrewing the bolts on the connecting clamp and removing it.
5. Unscrew bolts of a collar on a connecting joint of a turbocharger and the catalyst and remove a collar.
6. Unscrew two bolts of fastening of the catalyst and remove them together with lining washers.
7. Feed the catalyst towards the washer reservoir, turn it 90°to the right and remove it by pulling it up.
Attention! When performing this operation, do not damage the radiator. It is recommended to pre-cover the radiator with rags or cardboard.
The catalyst is installed in the reverse order of removal. Before installation, clean the sealing surfaces, check the condition of the connecting clamps and replace them if necessary.