Removal and installation the transfer case mode switching servomotor (Mercedes-Benz M-Class W163)

The details of the servomotor installation are shown in the illustration. The removal/installation procedures are described in the previous Section, if equipped, first remove the vibration damper (models 163.157) and a heat shield (models 163.157/175).

Transfer case shift servomotor installation details
1 - Electrical wiring connector; 2 - Support bracket; 3 - Mounting bolts; 4 - Mounting bolt; 5 - Nut

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article has been verified: Panova Maya Vladimirovna

Share with friends:

◀ Previous

M-Class W163 / Transfer case

Next ▶

Replacing the front output shaft seal
Replacing the rear propeller shaft output flange seal
Replacing the transfer case input shaft seal
Removal and installation the transfer case
Removal and installation the transfer case control module

Removal and installation of the planetary gear assembly of the transfer case center differential
Removal and installation of the transfer case bearing assembly
Removal and installation the transfer case oil pump
Removal and installation the transfer case shift mechanism
Removal and installation the transfer case reduction gear

More similar articles for repairing other models