Contents: Removal ↡ Installation ↡
Removal
1. Mark the installation position of the molding by placing a strip of tape above and below it.
2. Remove the molding from the door.
3. Remove any remaining sealant/adhesive from the back of the molding.
Installation
4. Apply the molding, without removing the protective film from the adhesive layer, to the seat on the door, align it and mark the seat with a washable marker. The rear end of the molding should match the edge of the door.
Original can be found on the website mercedesman
5. Remove the protective film from the adhesive layer, apply the molding to the door, following the marks, and press it down.